11/21/2023 0 Comments Auto vox t2 backup camera![]() This time, however, you will absolutely want to seal the hole once you have ran the wiring. You'll want to use the same drilling instructions from Step 1 now for Step 2. Plus, you generally don't have to worry about splicing issues.īut let's assume you don't. That's what is recommended for simple ease of install it's worth the extra money. Depending on your camera and system, you may have a plug-n-play set up. You'll then need to use your drill to make a hole from the inside of the bumper to the cabin of the car so that you can access the wiring from the head unit to the camera. Reach in and grab the wiring from the camera and pull it tight so that you have access to all of the wiring. Carefully remove the light and let it hang out of the way you do not need to disconnect wiring from the tail light. It's as simple as a Phillips head screwdriver and the top center of the tail light. Remove one of the tail lights on the passenger side of the car in order to gain access to your wiring. Step 2 – Run the wiring inside the bumper to the cabin of the car ![]() That extra protection can help increase the lifespan of the wiring, and potentially eliminate accidental wire exposure down the road. ![]() It can be a good idea to use some sort of additional protection for the wiring on this exterior hole. You can always increase the size of a drilled hole, you cannot decrease it. Start with a small hole when drilling and work your way up. Take your time while working this first step. Once you have the camera installed, push the wiring through the hole or opening you are using until the wiring is as much inside the bumper as possible. You can also use a rubber grommet to provide extra seal and hold for the wiring if you would like. If you choose to drill a hole, make it only as large as necessary to run the wiring through. Others may use a hole already in place above the license plate and run the wiring through there, again to keep from drilling additional holes. Some people will drill a hole behind where the license plate sits to run the wiring into the car. This eliminates drilling any more additional holes into the body of the car than necessary. The installation option here uses your factory bolts from the license plate frame holder to secure the camera mount. This step concerns the licence plate mounted camera. Read on for information regarding the installation of the camera and running the wiring from the back of the car to the head unit. This article assumes that you have already purchased and placed your backup camera capable head unit into your car.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |